Gasboy Tag Reader - Manual (Page 20)

Figure 2-3. Tag Reader Installation Holes, Internal View
2-5.2. General Instructions
The following paragraph provides step by step instructions for installation of the Tag Reader box.
1. Install the Tag Reader in a non-hazardous area in accordance with Figure 2-2.
2. Install the Tag Reader at a height suitable for LCD screen reading by an average driver.
3. Link the Tag Reader to the Controller (CFN PLUS, Islander Plus, Fuel Truck Controller or
other) with the RS-485 wires.
4. Connect Tag Reader to power supply
5. The installation procedures must meet all safety regulations in accordance with local state
regulations.
2-5.3. Mechanical Installation
In this configuration, the Tag Reader is installed on a pole or a wall. Proceed as follows:
1. Verify that the Tag Reader support flange is provided with holes suitable for attaching the
Tag Reader to it (see Figure 2-3)
2. Remove the four M4 x16 screws at the rear panel attaching the rear panel (see
Figure 2-4)
3. Remove the Grommet cap at the center of rear panel and pull out cable from the Tag Reader
4. Insert the free end of the Tag Reader cable through the 12 mm hole, and then place the Tag
Reader rear (with the rubber seal) in the prescribed position on the support flange
5. Attach the unit using four M4 x16 screws from the rear side
Tag Reader Installation Guide 16