Gasboy Tag Reader - Manual (Page 26)

3. The two Tag Reader indicators, green

and red

,
flash for a few seconds to indicate that it reads the
tag/card, a beep is heard, and the customer sees a
notification message:
4. After the tag/card is successfully read, only the green

indicator continues to flash. The Tag Reader waits for a
confirmation or rejection message from the station
controller, and notifies the customer to wait:
5. After tag/card OK is displayed, the customer can remove the tag/card.
6. If everything is OK, the station controller confirms the
transaction within 10 seconds. The green

indicator
turns on (or flashes) and the customer is notified to start
refueling:
7. After refueling is ended by returning the refueling nozzle
to its cradle, the customer see the following message:
Tag Reader Installation Guide 22
3-2. 3-2.
ERROR CONDITIONS ERROR CONDITIONS
In case an error occurs after the customer starts a refueling in accordance with para. 3-1, the red

indicator turns on (or starts flashing) and a beep is heard. The cause of the error is displayed on the
LCD.
 Error during the reading of information from the tag or
card. In this case, after step 3 the following message is
displayed: In this case, the customer should wait until the
welcome message appears, and bring again the tag/card
close to Tag Reader.
In case the problem occurs again, the customer should contact one of the station attendants.
 The tag/card is rejected by the station controller. In this
case, after step 5 the following message is displayed: In
this case, the customer should contact one of the station
attendants.