Gasboy Tag Reader - Manual (Page 23)

Tag Reader Installation Guide 19
2-5.5. 2-5.5.
Post-Installation Checks and Programming of
Tag Reader Address
Post-Installation Checks and Programming of
Tag Reader Address
Proceed as follows:
1. Restart the CFN PLUS
2. Monitor the power-up indications provided by the Tag Reader:
 Check that the green

and red

indicators turn on for a few seconds and then turn
off.
 Check that a single beep is heard.
 Check that the LCD displays Tag Reader
software version, followed by the welcome
message.
3. Observe the default OrTR address as displayed on the screen as the device is powered-up,
and then set the new OrTR address using the Host ORPT application, as follows:
a. Connect a PC on which the Host OrPT application was previously installed to OrTR
RS-485 connector via 8-Port Commverter or any other RS-485/RS-232 convertor
b. Run the Host OrPT application. The following screen is displayed (see Figure 2-6):
Figure 2-6. Host OrPT Main Screen
c. Click on the Scan button. The Scan/Set New Address dialog box appears (see Figure
2-7)