Gasboy Fuel Point Reader - Manual (Page 34)

GASBOY Fuel Point System
4-8 03/28/03
SERIES 1000 UPGRADE KITS
As mentioned earlier, your Fuel Point shipment may have included various upgrade kits for the
Series 1000 System. The Series 1000 needs the Auxiliary Communications PCB to communicate
to the Fuel Point Reader. If your Series 1000 doesn't have a tank monitor interface or a receipt
printer, start at the next section, Adding Auxiliary Communications and Comm. Port 1 Using
the C06822 Kit. If your Series 1000 has a tank monitor interface, you already have the Auxiliary
Communications PCB installed; proceed to Adding Comm. Port 2 Using the C06823 Kit. If your
Series 1000 has a receipt printer, you already have the Auxiliary Communications PCB and Port 1
cable installed; proceed to Field Wiring, Series 1000 AC Power and RS-485.
Adding Auxiliary Communications and Comm. Port 1 to Series 1000 Using the C06822 Kit
The C06800 Fuel Point system contains a C06822 kit for adding the communications board to the
Series 1000. It also contains a spare cable that can be used for a tank monitor, The contents of
the C06822 kit are shown below.
Qty Part Number Description Qty Part Number Description
2 C04291 Screw, 6-32 x 3/4 1 C05918 Cable, Auxiliary Comm.
1 067765 Fiber Washer 2 C04030 Screw, 8-32 x 3/4
2 C02896 PCB Support 1 C01695 Decal, "AUX. 12345 PORT"
1 C05909 PCB, Auxiliary Comm.
1. Remove the housing wrapper and access panels on the Series 1000.
NOTE: Refer to the drawings on the next page for this procedure.
2. Remove the two screws (a) located approximately 2-1/4 inches to the left of the buzzer on
the MPU board.
3. Install two C04291 screws (b) in their place. Start the screws from the inside so that the
threads protrude out through the MPU board.
4. The top screw already has a fiber washer glued to the MPU board. Add an 067765 fiber
washer to the bottom screw (c).
5. Add two C02896 PCB supports to the screws (d).
6. Push the C05909 Auxiliary Communications PCB (e) onto the standoffs. Make sure that
connector P1 on the bottom of the Communications PCB mates properly with connector J16
on the MPU PCB.
7. Attach the C05918 terminal block and cable (f) to the Series 1000 pedestal using two
C04030 screws. When installing the cable, the red wire from the terminal block must be on
the left.
8. Place the C01695 decal under the terminal block as shown (g).
9. Pass the cable (h) through the large nylon bushing at the top of the pedestal. Route the
cable under the MPU board and attach it to P3 on the Auxiliary Comm. PCB (e).
10. Proceed to the next section, Adding Comm. Port 2 to Series 1000 Using the C06823 Kit.