Gasboy Fuel Point Reader - Manual (Page 31)

Field Retrofit Instructions
03/28/03 4-5
Attaching the FPR to CFN Standard (Blank) and CFN Printer Pedestals
WARNING: Before proceeding, remove the rear access cover of the CFN pedestal to a
safe location away from the fueling island.
1. Turn off all breakers supplying power to the Fuel Management System pedestal. Remove
the pedestal's side access covers. Remove the pedestal's rear access cover and take it to a
safe location away from the fuel island.
2. Measure to the center of the cover and mark a vertical line as shown. Using the
measurements from the diagram below, mark and drill four mounting holes. For the conduit
hole, drill a pilot hole, then finish with a 1-1/8" diameter punch.
3. Hold the FPR against the rear of the access cover to make sure the five holes line up.
Attach the FPR using the four 068005 flat washers, C08875 gasket washers, 068891 lock
washers, and 038860 nuts as shown on the next page. Be sure to use the gasket washers
on the outside of the cover.
4. Proceed to Completing the FPR Mounting - All Pedestal Types.