Gasboy Fuel Point Reader - Manual (Page 27)

03/28/03 4-1
Section 4
FIELD RETROFIT INSTRUCTIONS
FIELD UPGRADE KITS
Use this section when you are installing a Fuel Point Reader (FPR) for use with an existing FMS.
If your FPR was shipped from the factory already attached to a GASBOY Fuel Management
System Pedestal, you do not need to reference this section.
Several kits exist to help you in the
retrofit. Use the chart on the right to
identify the appropriate retrofit kit
based on your system type.
Use Kit C06800 to add a FPR to a
Series 1000.
Use Kit C06801 to add a FPR to a
Series 1000 with tank monitor
interface, Series 1000P with printer, or
2000S CFN System.
FPR FIELD MOUNTING OPTIONS
There are four FPR field mounting options:
● Wall mount to a studded wall
● Wall mount to a masonry wall
● Pole mount
● FMS pedestal mount
ATTACHING FPR MOUNTING BRACKETS
Before mounting the FPR to a wall, pole, any FleetKey pedestal, or a CFN pedestal with built-in
Pump Control Unit, you must first attach mounting brackets from the C06800 or C06801 upgrade
kit. If the FPR is to be mounted to a CFN standard (blank) pedestal, or CFN receipt printer
pedestal, skip this step, as the mounting brackets are not used.