Gasboy Fuel Point Reader - Manual (Page 33)

Field Retrofit Instructions
03/28/03 4-7
Completing the FPR Mounting - All Pedestal Types
1. The Fuel Point Reader comes shipped with a nylon plug and nut. They may be installed in
one of the two machined conduit holes. When the FPR is pedestal-mounted, the plug and
nut must be installed in the machined conduit hole in the bottom of the FPR as shown in the
drawing on the next page.
2. Thread a 039210 nut onto the 021042 conduit nipple as far as you can, typically a few turns.
Add a 068444 washer, then a 048899 O-ring against the inside of the nut.
3. Insert the conduit assembly into the FPR, through the large hole on the rear wall. Working
from inside the FMS pedestal, install a 048899 O-ring, 068444 washer, and 039210 nut on
the conduit nipple. Tighten the nuts on both ends of the nipple. Snap a C09548 bushing into
each end of the conduit.
4. The C06778 and C06779 cables will be used in the wiring diagrams at the end of this
section.
5. See Section 2 for the applicable conduit installations.