beautypg.com

Gasboy M06875K00X User Manual

Page 13

background image

MDE-4556 Gasboy ATC Kits M06875K00X Installation Manual • July 2006

Page 13

Installation

2

Insert ATC Controller board into top slot of card cage.
If necessary, rearrange boards in the following order, top to bottom:

• T20569-G1 ATC Controller
• M05200A001 Retail Pulse Out
• T20011-G1 Pump Controller

3

Connect existing R17995-G7 cable to the following connectors (

Figure 6 on page 14

):

• P301 on T20569-G1 ATC Controller board
• P101 on M05200A001 Retail Pulse Out board
• P201 on T20011-G1 Pump Controller board

4

Unplug existing R19667-G1 cable from connector P205 of T20011-G1 Pump Controller board
(leaving other end connected to connector P105 of M05200A001 Retail Pulse Out board) and
connect loose end to connector P305 on T20569-G1 ATC Controller board (

Figure 6

).

5

Connect new R19667-G1 cable from kit to the following connectors (

Figure 6

):

• P405 on T20569-G1 ATC Controller board
• P205 on T20011-G1 Pump Controller board

6

Unplug existing R19951-G1 keypad cable from connector P203 of T20011-G1 Pump
Controller board and connect it to connector P303A on T20569-G1 ATC Controller board
(

Figure 6

).

7

Connect new R20146-G2 cable from kit to the following connectors (

Figure 6

):

• P303 on T20569-G1 ATC Controller board
• P203 on T20011-G1 Pump Controller board

8

Unplug existing T17768-G1 display cable from connector P204 on T20011-G1 Pump
Controller board and connect it to new R19527-G1 calibration switch cable from the kit
(

Figure 6

); connect the other end of the new R19527-G1 calibration switch cable to the P204A

connector on T20569-G1 ATC Controller board (

Figure 6

).

9

Connect other new R19667-G1 cable from kit to the following connectors (

Figure 6

):

• P304 on T20569-G1 ATC Controller board
• P204 on T20011-G1 Pump Controller board

10

Connect the existing R20128-G1 cable from the conduit to connector P307 on T20569-G1
ATC Controller board (

Figure 6

).