Installing atc controller board, Caution – Gasboy M06875K00X User Manual
Page 12
Installation
Page 12
MDE-4556 Gasboy ATC Kits M06875K00X Installation Manual • July 2006
Installing ATC Controller Board
Use the following guidelines when installing the K94160-01 software or handling sensitive
parts.
• Touch an unpainted metal surface to discharge any static electricity buildup.
• Use a wrist strap connected to a grounded metal frame or chassis. Dispenser must be
connected to an AC source with power OFF.
• Place removed PCBs or ICs, if any, on a grounded antistatic mat or in an antistatic bag.
The kit parts used in this section are:
• K94160-01 ATC Software Kit
• R19527-G1 34-conductor Calibration Switch Cable Assembly
• R19667-G1 34-conductor Ribbon Cable Assembly
• R20146-G2 10-conductor Keypad Interface Cable Assembly
• T20569-G1 ATC Controller Board
1
Insert K94160-01 software from kit into position U5 on the T20569-G1 ATC Controller board
(
).
Figure 5: T20569-G1 ATC Controller Board
The printed circuit boards (PCBs) and integrated circuits (ICs) within the dispenser are sensitive to
electrostatic discharge (ESD) caused by static electricity. ESD damages electronic parts.
CAUTION
wrist strap
Install K94160-01
software in position U5.
programming switch
· left = OFF (normal use)
· right = ON (program use only) – used in
“Programming the ATC Option” on page 18
JP1
used in
P307