Gasboy M06875K00X - Manual (Page 11)

MDE-4556 Gasboy ATC Kits M06875K00X Installation Manual • July 2006 Page 11
Installation
Installing I.S. Barrier Assembly
The kit parts used in this section are:
• K81105-20 Wire Nut Connector
• Two Q10178-03 Cable Ties
• T19428-G1 115 VAC ISB Assembly
1 Remove 3/4-inch plug from far right-hand opening on top of junction box.
2 Install ISB directly into junction box as shown in Figure 4 .
Figure 4: ISB Installation
3 Route ISB wires (with connector P1S) back onto ISB and secure with a Q10178-03 cable tie.
4 Run these wires up the junction box conduit and secure to conduit with Q10178-03 cable tie.
5 Connect P1S of the R20147-G1 cable ( Figure 3 ) to J1S of the ISB cable ( Figure 7 on page 15 ).
Locate connector in rail away from moisture.
The green, orange, and grey wires from the ISB are not connected at this time; they will be
connected later in
“Connecting ISB Wires and Cable” on page 15 .
T19428-G1
I.S. Barrier
Junction Box