Gasboy Atlas Discharge - Manual (Page 8)

Installing the M06228K001 or M06228K002 Kit
Page 8 MDE-4503 Atlas Discharge and Valve Conduit Retrofit Kit • July 2005
Figure 3: Valve/Filter Manifold Removal
To reassemble the unit:
Note: If the unit has hose hooks, check to see if there is a clinch stud in the frame, see Figure
5 , Item 1, if one exists, skip steps 14 through 17.
If there is no clinch stud:
14 Remove the hose hook.
15 Remove the screws that attach the sheathing to the lower frame.
16 Carefully pull the sheathing out enough to insert the stud (Item 1) through the retriever cutout
into the hole above the cutout as shown in
Figure 5 .
Note: The stud only needs to be inserted through the hole; it does not need to be pressed in.
17 Replace the sheathing screws and the hose hook.
Unit reassembly:
18 Thread the valve wires through the conduit and fittings to build the new conduit run from the
coil per
Figure 4 .
Hose Retriever Brkt (units with hose retrievers)