Gasboy Atlas Discharge - Manual

MDE-4503 Atlas Discharge and Valve Conduit Retrofit Kit • July 2005 Page 1
Introduction
This manual provides installation instructions for installing the Atlas Discharge and Valve
Conduit Retrofit Kit.
Under certain service and installation conditions where the internal dispenser piping, conduit
and mounting is distorted, some Gasboy Atlas units may develop a leak or inconsistent
solenoid valve operation. This kit prevents these occurances.
Required Reading
Before installing a kit, the installer must read, understand, and follow:
• This manual
• NFPA 30A, The Automotive and Marine Service Station Code
• NFPA 70, The National Electric Code
• Applicable federal, state and local codes and regulations
Failure to do so may adversely affect the safe use and operation of the equipment.
Note: This kit must be installed by a Gasboy Authorized Service Contractor (ASC) to ensure
warranty.
Required Tools
The following tools are needed to install this kit:
• Standard Wrench Set (Metric and SAE) w/universal joint and 12 inch extension
• Set of combination wrenches (Metric and SAE)
• Flat tip screwdriver
• Cross tip screwdriver
• Punches (to help line up bolt holes)
Caution
Failure to follow the procedure outlined with in this kit may result in a compromised effectivity of
this kit and could result in leaks or improper valve operation.
MDE-4503
Atlas Discharge and Valve Conduit Retrofit
Kit
July 2005