Gasboy 9800Q Series Diagnostic Manual - Manual (Page 66)

GASBOY Series 9800Q
5-10 01/28/04
REPLACING THE BALLAST CABLE ASSEMBLY
1. The platform assembly must be removed in order to replace the ballast cable assembly.
See Replacing the Platform Assembly earlier in this section. Proceed to Step 2 once
platform assembly is removed.
2.
Using a slotted screwdriver, apply pressure to the retaining tab on one side of the LIGHTS
connector [1] on the power bracket, then push the connector in through bracket.
3.
Disconnect the lamp cable assemblies [2] from the ballast cable assembly on the front and
rear of the platform.
4.
Using a slotted screwdriver, apply pressure to the retaining tab on one side of each ballast
connector [3], then push the connectors down through the platform.