Gasboy 9800Q Series Diagnostic Manual User Manual
Page 19
Electronic
Head
Assembly
01/28/04
3-3
Connectors
Connector P1 controls side 1 and P2 controls side 2. The AC IN and NEUT pins are used as a
pump authorization signal when SW1-6 is closed. The AC IN also feeds the SF, FF, and SUBM
relays. The SF and FF outputs can directly power the solenoid valves. The SUBM output can
power a customer-supplied submersible starter relay. The starter relay’s coil current must not
exceed 300 mA.
P1 and P2 - AC Input, Valve, and Submersible Relay Outputs
P3 - Side 1 Pulser Input, P5 - Side 2 Pulser Input
P4 - Handle Switch Inputs
NOTE: Pin 2 and Pin 4 are not used on the Front Load option.
See also other documents in the category Gasboy Hardware:
- 216S (18 pages)
- Atlas Fuel Systems Site Prep Manual (42 pages)
- Atlas Technician Programming Quick Ref (2 pages)
- ATC M05819K00X Kits (28 pages)
- Atlas Fuel Systems Owner Manual (80 pages)
- Gilbarco Global Pumping Unit Operation Manual (42 pages)
- 26 (7 pages)
- Atlas Valve Replacement Kits (10 pages)
- Atlas Fuel Systems Installation Manual (100 pages)
- 9120K (8 pages)
- 9820K (6 pages)
- Atlas Single Std. Inlet Centering Kit (8 pages)
- 8800 Atlas (1 page)
- 9120K Series Service Manual (40 pages)
- 9800A Atlas (6 pages)
- 9800 Atlas (14 pages)
- 9800 Atlas (20 pages)
- M08400 (6 pages)
- 9100 Series (8 pages)
- 9820K Series Installation (62 pages)
- 9853K (8 pages)
- 9216KTW (36 pages)
- Recommended Spare Atlas (14 pages)
- DEF Atlas (28 pages)
- 9820K Series (12 pages)
- 9800Q (1 page)
- Q Series (3 pages)
- 8753E (2 pages)
- 9152AXTW2 (1 page)
- 8800E (2 pages)
- 8800E (1 page)
- 9820Q Series (1 page)
- Atlas Start-up (230 pages)
- 2600A (12 pages)
- 2600A (2 pages)
- 9800Q Front Load Vapor (2 pages)
- 215A (1 page)
- 9800A (4 pages)
- 9820A (1 page)
- 2600A (3 pages)
- 216A (31 pages)
- 215A (2 pages)
- 9800Q Vapor (2 pages)
- Lamp Kit (2 pages)
- 9120Q Pulser (1 page)