Gasboy Atlas Fuel Systems Site Prep Manual - Manual (Page 5)

MDE-4333E Atlas Fuel Systems Site Preparation Manual · November 2011 Page 1
Read this First Introduction
1 – Introduction
Read this First
Purpose
This manual gives you information to prepare a site for Gasboy ® Atlas ™ Series pumps or
dispensers. It provides the following:
• Safety information
• Equipment required for installation
• Station layout information
• Electrical requirements
• Plumbing requirements
Perform all site preparation in accordance with NFPA 30A, NFPA 70, and applicable national,
state, and local codes/regulations. For non-US installation, other codes may apply. Plan your
site ahead of time. Use experienced, licensed personnel that practice accurate, safe
construction techniques. Time, expense, and extra effort in the early stages of preparing a site
can eliminate problems in later stages. Careful site preparation provides a sound
troubleshooting framework for field repairs. For additional information, consult manufacturer
installation instructions. This manual does not list all requirements for installation of outside
vender components.
Who Must Use this Manual
This manual is intended for individuals who are trained in the construction of gasoline
stations. If you do not have experience with this type of construction (gasoline stations),
contact a licensed, trained engineer or contractor, or Gasboy Authorized Service Contractor
(ASC).
Whom to Contact
For this Type of Information Call the Following Phone Numbers
To schedule training on Gasboy products Your local Gasboy distributor
For technical assistance Gasboy Technical Support at 1-800-444-5529
For warranty service and information Gasboy Call Center at 1-888-800-7498
For explanation of Gasboy’s warranty policy Contact your local Gasboy distributor
For additional technical literature, for example, installation,
parts manuals, and other documents Gasboy Literature Department at 1-336-547-5661
Solutions, Products, Services, and Support http://www.gasboy.com