Foxconn 865A05-G-6ELS - Manual (Page 52)

46
Chapter 3 BIOS Description
865A05 G/P/PE/GV User Manual
Load Optimized Defaults
Load Fail-Safe Defaults
Select this option to press Enter, it will pop out a dialogue box to allow you to load
default set by BIOS. Select and then press Enter to load default. Select
and press Enter, it will not load. The defaults set by BIOS have set the basic
functions of system in order to ensure the stability of system. But if your computer
fails to properly run, you may load failure insurance default to make the system
recover normal, then carry out failure testing in next step. If you only want to load
the default in an option, you can select this option and press the key F6.
Select this option and press Enter, it will pop out a dialogue box to let you load the
optimized defaults set by BIOS. Select and then press Enter to load the
optimized defaults. Select and press Enter, it will not load. The defaults set
by BIOS have set the optimized performance parameters of system to improve
the performances of system components. But if the optimized performance pa-
rameters to be set cannot be supported by your hardware devices, it will cause
system to make mistakes or not stable. If you only want to load the optimized
default in an option, you can select this option and press the key F7.
Set Supervisor/User Password
The preferential grade of supervisor password is higher than user password.
You can use supervisor password to start into system or enter into CMOS setting
program to amend setting. You can also use user password to start into system,
or enter into CMOS setting menu to check, but if you have set supervisor password,
you cannot amend setting.
W hen you select Set Supervisor / User Password, it will appear the following
message in the center of screen, which will help you to set password.
Enter Password:
Enter your password, not exceeding 8 characters, then press , the pass-
word you enter now will replace the previous password. W hen the system re-
quires you to determine this password, you can enter this password and press
.
If you do not need this setting, you can press when the screen prompts
you to enter password, and the screen will appear the following message to
show this function invalid. In this case, you can freely enter into system and
CMOS setting program.
PASS WORD DISABLED!!!
Press any key to continue...
Under the menu “Advanced BIOS Features Setup”, if you select “System” in Secu-
rity Option, the screen will prompt you to enter password once the system is
started or you want to enter CMOS setting program. If the password is wrong, it
will refuse you to continue.
PDF created with pdfFactory Pro trial version www.pdffactory.com