Foxconn 865A05-G-6ELS - Manual (Page 37)

31
Chapter 3 BIOS Description
865A05 G/P/PE/GV User Manual
v Swap Floppy Drive (Default: Disabled)
If it set as Enabled, the label of FDD A and B can be exchanged. The available
setting values are: Disabled and Enabled.
v Boot Up Floppy Seek (Default: Enabled)
If it set as Enabled, BIOS will activate the floppy drive during the system boot,
and the drive
’s indicator will flash after the activation.The magnetic head will
move back and forth from A to B. The available setting values are: Disabled and
Enabled.
v Boot Up NumLock Status (Default: On)
This option is used to set up the NumLock status after the startup. When it is
set to On, the NumLock will be activated during system startup. When it is set to
Off, users can use the number keys instead of the arrow keys to move the cursor.
The available setting values are: On and Off.
v Gate A20 Option (Default: Fast)
This option is used to set up the A20 signal control necessary for access also
to the 1MB memory. The available setting values are: Normal and Fast.
v Typematic Rate Setting (Default: Disabled)
When it is set to Enabled, the 2 subsequent options can be activated; when it is
set to Disabled, the 2 subsequent options will be closed.
v Typematic Rate (Chars/Sec) (Default: 6)
Used to set the repeat rate for keyboard input of the same letter.
v Typematic Delay (Mec) (Default: 250)
Used to set the repeat keyboard input rate when pressing a key continuously.
v Security Option (Default: Setup)
When it is set to Setup, a password is required to enter the CMOS Setup screen;
When it is set to System, a password is required not only to enter CMOS Setup,
but to startup your PC, as well.
v APIC Mode (Default: Enabled)
This option is used to open or lock the APIC mode built into the chipset. The
available setting values are: Disabled and Enabled.
PDF created with pdfFactory Pro trial version www.pdffactory.com