Chapter 2 installation instructions, Wake-up on lan header: wol, Attention – Foxconn 865A05-G-6ELS User Manual
Page 23: S-ata headers: cn21, cn22
17
Chapter 2 Installation Instructions
865A05 G/P/PE/GV User Manual
Wake-up On LAN Header: WOL
Connect the header to the corresponding online wake-up output on the network
card. The system will wake up from sleep mode when the wake-up signal is sent
to it.
Attention:
1. This function will not work unless a) it is supported by the network card, and b)
the ATX power supply is 5VSB>=720mA.
2. Set the Wake-up by PCI Card to
“Enabled” in the Power Management Setup of
BIOS. Save the settings, exit the BIOS, and restart the system to enable the
setting.
WOL
Signal for waking up
+5V standby
GND
S-ATA Headers: CN21, CN22
The S-ATA headers are used to connect the S-ATA devices to the motherboard.
SATA1/SATA2
G
N
D
G
N
D
G
N
D
R
X
+
R
X
-
T
X
+
T
X
-
PDF created with pdfFactory Pro trial version