beautypg.com

Chapter 3 bios description – Foxconn 865A05-G-6ELS User Manual

Page 47

background image

41

Chapter 3 BIOS Description

865A05 G/P/PE/GV User Manual

v

Video Off In Suspend (default: Yes)

This option is used to determine whether the audio is turned off when the
system enters sleep mode.The setting values are No (not closed) and Yes
(closed).

v

Suspend Type (default: Stop Grant)

This option is used to set sleep mode. The setting values are Stop Grant
(saves the status of the whole system and then turns off power), and PwrOn
Suspend (CPU and core system go to low power mode, keeps power supply).

v

MODEM Use IRQ (default: 3)

This option is used to set the Modem interrupt signal. The system will auto
matically wake up when the Modem receives an incoming call. At the same
time, connect Fax/Modem to WOM joint in main board.

v

Suspend Mode (default: Disabled)

This option is used to set the idle time before the system enters into sleep
status. The setting values are Disabled and 1 Min-1 hour.

v

HDD Power Down (default: Disabled)

This option is used to turn off hard disk power if the hard disk is idle for a given
period of time. The setting values are Disabled and 1 Min-15 min.

v

Soft-Off by PWR –BTTN (default: Instant - Off)

This option is used to set the power down method. This function is only valid for
power joint using ATX. W hen

“Instant - Off” is selected, press the power switch

to immediately turn off power. When

“Delay 4 Sec” is selected, press and hold

the power button for four seconds to turn off power.

v

CPU THRM – Throttling (default: 50.0%)

This option is used to protect the CPU from overheating. The CPU will be forced
into idle mode after the protection mechanism is turned on. What we want to
set is the percent ratio that the idle time of CPU occupies whole operation time.
The higher this setting is, the lower the temperature of CPU decreases. The
setting values are 12.5%, 25%, 37.5%, 50%, 62.5%, 75%, and 87.5%.

v

Wake-Up by PCI card (default: Enabled)

This option is used to set the system to wake up by PCI card. The setting values
are Disabled and Enabled.

PDF created with pdfFactory Pro trial version

www.pdffactory.com

This manual is related to the following products: