Formax 6606 Series - Manual (Page 64)

Adjust
the Production Feeder Document Separation
When
the Production Feeder is used at an automatic separation feeder, the separation is
set
automatically.
The
Production Feeder can also be used on a feeder position with a manually adjusted
separation.
To adjust, proceed as follows:
Remove the document feeder trays 2 and 3.
The lowest feeder is feeder 1.
1.
2. Squeeze the two blue handles A and B and shift the feeding plate C as far as possible
to the front.
3. Push knob D forward until it clicks.
4. Place a document/BRE on the feeder tray and slide it in the system till the leading
edge is not visible anymore. Turn knob D counterclockwise if the separation is set to
narrow.
5. Push the document/BRE between the rollers.
6. Turn knob D clockwise to get more resistance and counterclockwise if the separation
is set to narrow.
The separation is adjusted correctly when a slight resistance is felt on the
document/BRE.
7. Pull knob D back when ready.
8. Replace the document feeder trays 2 and 3.
60
| Page 60 | feb-24-2014 01:32 | Loading the System
4
English