Formax 6900 Series User Manual

Page 8

7/40

Fig. 9

5.2

Switching on

Switch on the inserter using the power switch A, see Fig. 9.
If the AS-1A, PS-3 or franking machine etc. are part of the

system switch these on. Refer to the operator manuals of the

used modules if necessary.
After switching on the pin code screen or the main menu will

appear. In case the pin code screen appears, see section

5.3 for further instructions. In case the main menu screen

appears, see section 5.4 for further instructions.

Fig. 10

5.3

Entering the personal pin code

In Fig. 10 the pin code screen is shown.
Enter your pincode using the keys 1 to 6. If the code is not

correct, a warning “wrong code, try again” will be

displayed. This warning disappears immediately when a

key is pressed.
The pincode screen is not displayed if only the supervisor

code is defined. In this case the main menu as shown in Fig.

11 will be displayed after switching on the system.

Fig. 11

5.4

The main menu

The main menu is shown in Fig. 11.

The "main menu" shows 6 different functions:
• go to job info screen (key 1).

• go to the "select job" menu (key 2).

• go to the "test run" menu (key 3).

• go to the "change counters" menu (key 4).

• go to the "settings"menu (key 5).

• go to the "entry to the job menu" (key 6).

Key

4
5
6

Key

4
5
6