Formax 6900 Series - Manual (Page 7)

6/40 6/40 6/40 6/40
Fig. 7
4.6 4.6 4.6 4.6 Display keys Display keys Display keys Display keys
Key 1 through 6 Key 1 through 6 Key 1 through 6 Key 1 through 6
See Fig. 7 . These keys correspond with the function in the
display.
Start key Start key Start key Start key
The system will start to operate.
For more details see 6.2 on page 22.
Stop key Stop key Stop key Stop key
The system will stop operating.
Clear key Clear key Clear key Clear key
The system will first finish all documents sets that have
already been fed (e.g. to the transport track) by the feed
units, then it stops.
Esc. key Esc. key Esc. key Esc. key
Use this key to exit a (sub) menu without saving any
(altered) settings.
Fig. 8
5. 5. 5. 5. OPERATING THE SYSTEM OPERATING THE SYSTEM OPERATING THE SYSTEM OPERATING THE SYSTEM
5.1 5.1 5.1 5.1 Preparations inserter module Preparations inserter module Preparations inserter module Preparations inserter module
The bottle A (Fig. 8) must always be filled with water and
the brushes must be moistened. An extra set of brushes is
provided so that one set can be soaked in water whilst the
other set is used. This means there is always a clean set of
brushes ready for usage.
Before moving the system, the bottle and
watertray must be removed.
Refer to the other operator manuals of the used modules for
the required preparations.
If the system is switched off after, for example, a paper
stoppage, the brushes will not rest on the watertray. This
causes the brushes to dry if usage is interrupted for a longer
period.
Always take care that the brushes rest on the watertray.
Therefore the system must be switched on again so that the
brushes will rest on the watertray. The system can then be
switched off.
Key
1
2
3
4
5
6
job number
job name
job counter
preset counter
counter