Formax 6900 Series - Manual (Page 11)

10/40 10/40 10/40 10/4
5.4.2 5.4.2 5.4.2 5.4.2 Schematic view Schematic view Schematic view Schematic view
Info shown: Info shown:
Info shown:
means: means:
means:
114
Job data symbols Job data symbols Job data symbols
Job data symbols
Stop after
thickness err.
The hopper A is selected, envelopes
of 114 mm are fed and sealed.
The hopper B is selected.
Both hoppers are selected.
Thickness error detection is activated.
The preset counter is set to
250 document sets.
Sorting choice
Exit 1
Exit 2
yes
No fold
Single fold
Letter fold
Zig-zag fold
Double
parallel fold
Inserting module Folding module Feeding and accumulation module
The sorting module will sort on
envelopes.
The envelopes fed from hopper A, will
leave the sorter from Exit 1.
The envelopes fed from hopper B, will
leave the sorter from Exit 2.
The system will stop when a thickness
error is detected.
Transport module
Envelopes
No fold
Stop at 250
One document is fed.
More documents are fed.
Documents with enclosures are fed.
Info shown: means:
297
6
The lenght of the fed documents is shown.
The number of the fed documents from the
feeder station(s) or accumualation station is
set to 6.
Optical mark reading is selected (only
available for the accumulation station).
The feeder is selected and used in the job.
The hopper A is linked with the feeder.
This symbol is shown under the feeder or the
accumulation station if the address carrying
document is fed from it.
The hopper B is linked with the feeder.
Thickness detection is activated.
Downstream
modules
Sorting module
Upstream modules
and
and
See pages 17, 18, 19
and the Guide for job menu.
See pages 20 and 32 and
the Guide for job menu.
See page 20 and the
Guide for job menu.
Refer to operator manuals:
FE 7, FE 8, FE 9, AS 1A, BB 1
and the Guide for job menu.