Formax 6900 Series - Manual (Page 20)

19/40 19/40 19/40 19/40
6. 6. 6. 6. PERFORMING A JOB PERFORMING A JOB PERFORMING A JOB PERFORMING A JOB
6.1 6.1 6.1 6.1 Setting up the system Setting up the system Setting up the system Setting up the system
Switch on the inserter IN-3 and, if part of the system, the AS-1A and PS-3 etc.
Refer to the operator manuals of the used modules.
Inserter IN-3
Inserter IN-3 Inserter IN-3 Inserter IN-3
Action Action Action Action Refer to.. Refer to.. Refer to.. Refer to..
• Check the waterlevel, refill if necessary Refer to section 5.1 Preparations inserter module on page 6
• If required, enter pincode to gain access to the main menu Refer to section 5.3 Entering the personal pin code on page 7
• Select the required job
To recognize the correct job number, all jobs should have been given names. If so, the name is visible in the
framework under JOB X.
Refer to section 5.4.3 Selecting a job on page 11
• Press the Job info key. Use the job info facility as a guide to put the envelopes at the correct enve-
lope hoppers and the documents at the correct feed stations.
Refer to section 5.4.1 Job info screen overview on page 8
• After the correct job has been selected press the OK key to confirm. Now the job information will
be sent to all modules.
Refer to section 5.4.3 Selecting a job on page 11
• Set the envelope hopper side guides and separation Refer to section 5.7 Envelope hopper adjustment on page 17
• Enter the test menu, press the 1x envelope key to bring an envelope onto the insert table.
• Check the envelope stop position, adjust if necessary.
• Set the envelope fingers
Refer to section 5.4.4 Test run menu on page 11
• If necessary, enter the counters menu to change or reset the counters. Refer to section 5.4.5 Counters menu on page 14
• If necessary, enter the settings menu to check the thickness detector settings. Refer to section 5.4.6 Settings menu on page 14