Formax 6900 Series User Manual

Page 32

31/40

Fig. 35

9. MAINTENANCE

MAINTENANCE

9.1

General

The IN-3 requires just a few maintenance activities for the

operating personnel. These are:
• general cleaning.

• cleaning the brushes.

• cleaning the moistening cloth.

• cleaning the sealing roller.

Disconnect the mains supply before performing

any maintenance.

The user must not attempt to service the

appliance beyond that described in this

operator manual. All other servicing must be

carried out by qualified service personnel only.

Please contact your authorized distributor.

Fig. 36

9.2

General cleaning

The machine must be kept in proper condition by regularly

removing dust, paper remains, etc. Clean the sealing table

and rubber rollers when dirty. This can be done by using a

slightly wetted cloth.
9.3

9.3

Cleaning the brushes

Clean the brushes when dirty or saturated with glue. An

extra set of brushes is provided. The best procedure is to

always soak one set of brushes and use the other set. In that

way there is always a clean set of brushes ready for usage.
To replace the brushes the transparent cover and loc must

be lifted. The loc can be released by pulling the release

handle of the loc (see Fig. 32). The brushes can be removed

one by one by pulling them straight off the brush holder (see

Fig. 35). When replacing the brushes, align the studs on

each brush with the respective holes in the holder.

Fig. 37

9.4

Cleaning the sealing roller

The sealing roller A (Fig. 36) must be cleaned regularly with

a slightly wetted cloth.
9.5

9.5

Cleaning the moistening cloth

Clean the moistening cloth A (Fig. 37) and water tray when

dirty or saturated with glue. To remove the watertray the

transparent cover, loc (by pulling the release handle) and

sealing table (by pulling the locking handle) must be lifted.
Remove the bottle C and then remove the watertray B by

pulling it towards the hopper. Clean the water tray under

running water.