Formax 6900 Series - Manual (Page 26)

25/40 25/40 25/40 25/40
Fig. 29
7.1.2 7.1.2 7.1.2 7.1.2 The information screen The information screen The information screen The information screen
By pressing key 1 in the error screen, an additional
information screen as shown in Fig. 29 is displayed.
This screen shows more information about the cause of the
error. In this screen also the error code of the error is
displayed. For a complete description of the error codes
chapter 8.
7.1.3
7.1.3 7.1.3 7.1.3 The warning screen The warning screen The warning screen The warning screen
A warning screen is displayed when a refill is necessary. An
example of a message screen is shown in Fig. 30.
Resetting the machine
Resetting the machine Resetting the machine Resetting the machine
After refilling, the machine can be reset by pressing key 6.
The message screen will disappear.
Fig. 30
Configuration message Configuration message Configuration message Configuration message
The following message can occur if a job is selected in the
“job edit” menu:
“System differs from job data. Not corresponding modules
need to be set”.
When selecting a job, the system checks the current device
configuration with the device configuration as stored in the
job.
The operator can either ignore the message and continue
(soft key 6) or cancel the job editing.
This message is not displayed if the replaced or removed
device is switched off for this job, or if the replaced or
removed device has no job settings (i.e. FO-2A or TR-1B
plus foot switch).
If an FO-2A is replaced by an FO-3, the following default
settings for the FO-3 will be used:
• Envelope length > document length A4 + 6 mm margin.
No fold.
• Envelope length > document length ½A4 + 6 mm margin.
Single fold with A = 149 mm.
• Envelope length > document length 1/3 A4 + 6 mm
margin. Letter fold with A = 97 mm and B = 197 mm.
• Envelope length < document length 1/3 A4 + 6 mm
margin. Double parallel fold with A = 200 mm and B =
100 mm.
If the envelope length isn't yet known, the default envelope
length is used.
Key
1
2
3
4
5
6
Key
1
2
3
4
5
6