Formax 6900 Series User Manual

Page 23

22/40

Fig. 27

6.2

Running a job

Start

Test cycle

After all settings have been carried out a few test cycles can

be made by using the "insert one document" function, see

section 5.4.4 page 12 or see fig 27.
Automatic operation

When correct insertion is obtained, start automatic

operation by pressing the "Start" key.
When the “start” key is pressed (after switching on and no

other job is selected), the job information is sent to all

machines in the system. During this time an egg timer will

appear for about 10 seconds. When ready, the system

starts operating.

If documents from a previous job are detected on the

transport track (TR-7A), these are transported to the

collating area of the TR-7A. The system then stops and

indicates that these documents have to be removed.

Remove and press the start key again.

Stop

Stop
Press the stop key to stop the system.

Job finishing

The system can be cleared during the running of a job or

after running out of address carrying documents.

To clear the system, press the clear key. The system will finish

all documents sets that have already been fed (e.g. to the

transport track) by the feed units. Then the system stops.
In case a transport unit is part of the system, see TR-7A

operator manual chapter 6.
With the 6900 Series, use the inserter clear key instead of

using the TR-7A reset key.
With the 6900 Series, remarks about the inserter "pause"key

are not applicable.

Stoppages

In case of a stoppage, refer to chapter 7 and 8.

Key

4
5
6