Englis h – Formax 6302 Series User Manual

Page 47

ENGLIS

Symptom

Possible cause

Remedy

Refer to section

The machine is
not starting after
switching ON

Machine not
connected to power

Connect the machine
to the main power

Fuse blown

Replace fuse below
power switch

A cover is opened Close the cover(s) -

Machine stops
with envelope at
insert position
(flap not open)

Envelopes stacked
reversed in the
hopper

Check envelope feed
adjustments. Place
envelopes correctly
in hopper

Envelope flap sticks

Store envelopes
according to
specifications

Envelope specifications

Wrong envelope type
used (not according
to specifications or
job settings)

Change envelopes
according to
specifications

Envelopes are
double fed

Envelope separation
not correctly
adjusted

Check separation
settings, adjust if
needed

Envelopes not placed
properly in the
hopper

Check and replace if
needed

Envelope stop
skewed

Side guides of the
envelope hopper are
set too wide

Check side guides
and adjust if needed

Envelopes are fed
irregularly

Hopper almost empty Refill hopper

Separation set too
narrow

Check separation
settings, adjust if
needed

Side guides set too
narrow

Check side guides
and adjust if needed

Envelope support not
positioned correctly

Reposition the
envelope support