Formax 6302 Series - Manual (Page 44)

42
9. FAULT DETECTION
9.1 Error Messages
When an error occurs the display shows a screen
showing the following information:
- An indication of the area in which the error
occurred.
- An error description.
- A suggested solution next to the pointing
hand.
Press to view more information about
the error and about the possible actions to prevent
the error from recurring.
After solving the problem, press to
reset the machine (the error screen will disappear).
Special Errors
• Reading errors (when Optical Mark Recognition is enabled)
The document stops in the collator area. The operator must remove the document(s)
from the collator area and must complete the set manually.
• Technical errors
The display shows a message. The error cannot be solved by operating personnel and
assistance of the service support is needed.
Warning screen
When a cover is opened, the display shows a warning screen with the message “Cover
Open" and a suggested solution “Close Cover”. The black arrow or a black feeder indicates
where the problem occurred.
Reset
Envelope too short
Remove envelope
!
Check envelope type and envelope
job settings
INS: 22
Envelope length measured is shorter
than expected
Reset