Formax 6302 Series - Manual (Page 39)

37
ENGLIS
H
Additional marks
When it is required to control more functions in the
inserter system, the use of more marks is needed.
The following additional functions are available via
software options:
- divert mark
- stop mark
- 1 mark: selective feed from station 1
- 1 mark: selective feed from station 2
- 1, 2 or 3 marks: respectively sequence check
4, 2 and 1
- 1 mark: parity check mark (even)
- 1 mark: safety mark
General remarks:
- The marks must always be used in the above sequence.
- If a function is suppressed, the following function will move upward one line.
- The chosen code must always be used on all material to be processed by
the Optical Mark Recognition system.
- The length of the code and the mark definition is a service setting.
- Other marks/functions are available via special codes (Flex codes)
Divert mark
The machine stops; manually remove the set from the collator. Reset and start again.
Stop mark
The machine stops; manually remove the set from the collator. Reset and start again.
Selective feed mark
The machine will selectively feed an enclosure when commanded so.
Sequence check
Sheets in a stack can accidentally get out of sequence or can be missing. This can be
detected by the sequence check.
Each sheet has a binary code that is a part of the reading code.
Parity mark
By adding a parity mark the reading code can be checked. When the OMR-2 code is used
the sum of the marks has to be even.
Start mark
Divert mark
Stop mark
Insert/accumulate
Selective feed 1
Selective feed 2
Sequence check 4
Sequence check 2
Sequence check 1
Parity (even parity)
Safety mark