Formax 6302 Series - Manual (Page 41)

39
ENGLIS
H
7. OPTIONS
7.1 production Feeder
Function
The production feeder is a feeder that can be loaded with a large number of documents.
this feeder is intended to be used for Business Reply Envelopes (BRE), but it will also accept
"standard" documents up to 156 mm length.
Preparations
The production feeder should be installed at the position
of feeder no. 1.
It can be placed into position in the same way as the
other document feeders are fitted.
Proceed as follows:
1. Lift the paper feed rollers with the front edge of
the production feeder.
2. Move the production feeder forward until it hooks
behind the frame axle.
3. Connect the connector A to the socket B.
The production feeder is auto-detected by the system
when it is switched ON. This makes it easy to switch
over from the standard document hopper to the production feeder and vice versa.
Note
To allow easier installation of the production feeder, put the feeding plate in the
rear position (see section "Separation").
To make use of the production feeder it is not necessary to (re-)program the jobs.
Adjusting Side guides
Adjust the side guides:
1. Take a stack of documents/BREs and place them
in the feeder tray.
BREs with flap down and leading (top side
pointing to machine).
2. Adjust the side guides by turning the
thumbwheel G so the documents/BREs just fit
and can move without resistance.
Too much play causes skewing.
A B
G H I J