Formax 6302 Series - Manual (Page 17)

15
ENGLIS
H
5. After a few seconds, the AutoSet
TM
display will
appear.
6. Press to load one envelope to the
insert position in the machine.
7. The envelope is visible through the window in
the top cover.
Insert Position
Note
This adjustment must only be checked in case of problems or when changing the envelope
type.
Check if the flap folding line is positioned
underneath the green roller B. If not adjust the
Insert position as follows:
1. Press on the left or right side of to
adjust the insert position to the left or the right.
2. Press to load a new envelope into
the insert position
3. Recheck the insert position, and adjust as
required.
4. If necessary adjust the “envelope insert
fingers”:
- Open the top cover.
- Adjust the outer fingers D approximately 5 - 10 mm (0.2 till 0.4”) from the edges of
the envelopes.
- Loosen the knurled knobs C.
- Adjust the fingers A so that the tip is approximately 5 mm (0.2”) inside the
envelope.
- Tighten the knurled knobs C.
1x
1x
AutoSet
Insert position
ESCAPE
1x
A
B
C
D
1x