Formax 6302 Series - Manual (Page 30)

28
Note
The maximum number of sheets in a set is 25. When the number of sheets exceeds 6 or
8, depending on the fold, the document can no longer be folded. In this case, the
maximum length of sheets should be set to 148 mm for a C5/6 envelope. Also make sure
that the fold setting is
No fold.
Ignoring this will certainly lead to stoppages.
When the maximum number of sheets exceeds the programmed maximum number of
sheets in a set, the machine stops and error VT:134 will be displayed. After removing the
set and pressing the RESET button, the machine will start and repeat the process until an
insert or divert mark is encountered, error VT:135 (final set part) will be displayed.
• Press to view the programmed OMR
codes.
Refer to “OMR Codes” on page 35 for a description
of the OMR codes.
• Press to return to the previous OMR
settings screen.
Double Feed Control Settings
This screen is used to set the Double Feed Controls
(DFC) settings for the different feeders ON or OFF.
Press to select a feeder. The selected feeder will
be highlighted.
• Press to switch the DFC control ON or OFF.
When switched ON, a icon is visible beside the
relevant feeder.
• Press to confirm changed settings or press
to return to the previous screen without
changing settings.
JOB 8
Line spacing
6.00 Lpi
4.23 mm
Start mark
Insert on mark
Parity check
Safety mark
OK
OMR SETTINGS
OK
JOB 8
ESCAPE OK
1
2
3
DFC SETTINGS
OK
ESCAPE