Formax 6302 Series - Manual (Page 42)

40
Document Separation
When the production feeder is used as an automatic separation feeder, the separation is set
automatically.
The production feeder can also be used on a feeder position with a manually adjusted
separation.
To adjust, proceed as follows:
1. Remove feeders 2 and 3.
2. Squeeze the two blue handles C and D and shift
the feeding plate F as far as possible to the
front.
3. Push knob E forward until it clicks and turn it
counterclockwise as far as possible.
4. Place a document/BRE on the feeding tray and
slide it in the machine till the leading edge is no
longer visible.
5. Push knob E forward until it clicks and turn it
clockwise till a slight resistance is felt when
moving the document/BRE in and out of the
machine.
When the resistance becomes too strong,
turn knob E counterclockwise.
6. Pull knob E back when ready.
7. Remount feeders 2 and 3.
Feeding Documents
1. Squeeze the two blue handles C and D.
2. Shift the feeding plate F to the rear position.
3. Loosen the stack of documents and place them in the feeder.
BREs with flap down and leading (Top side pointing to machine).
The feeding plate assembly will shift up automatically (when the system starts
processing) until documents/BREs are underneath the rubber paper pullers.
Note
When filling the production feeder, make sure that the document/BREs are positioned parallel
in relation to the feed plate to ensure correct feeding.
7.2 Intermediate Transport
This option enables the handling of smaller documents from feeder no. 3 (top tray).
This option is not available in combination with Optical Mark Recognition.
Minimum document height
Without Intermediate Transport 115 mm (4.5”)
With Intermediate Transport 90 mm (3.5”)
C D F
E