DNF Controls GTP-32 - Manual (Page 6)

- 6 -
ETHERNET LINK SPEED SETUP
1) On GTP-32 front panel, use éê keys to select “Ethernet
Status”.
2) Press ENTER key. Display will show current speed selection.
3) Use éê keys to change selection.
Select AUTO to use highest available speed.
Select 10Mbs for long ethernet cable runs.
4) Press ENTER to save new Ethernet link speed, or press ESC to
exit without saving.
NOTE- New ethernet speed selection will take effect immediately.
SETUP
Setup is required after initial installation. Setup may also be required after
changing external GPIs or GPOs.
Setup is performed using a computer running an off the shelf web browser
such as Internet Explorer or Firefox. Connect the CAT5 cable from the
computer to the same ethernet switch that the GTP-32 is connected to.
After launching the web browser, enter the IP address of the GTP-32 to be
setup. The GTP-32 Home Page will be displayed.