DNF Controls 2044CL_(-A, -O, -NX, -7, -8, -T, -P) - Manual (Page 34)

Function Key Press Description
OR press any transport key to exit SLOMO.
SLO-MO SPEED
PRESET [SHIFT] +
[SLOMO] For WHEEL ONLY: Press [SHIFT] + [SLOMO] to
preset the slo-mo speed. Turn the Wheel to select
desired speed.
Press [ESC] or any transport key to exit.
STOP [STOP] Press once to STILL frame VTR.
Press again to put VTR into STOP mode.
RE-SYNC GANG [SHIFT] + [STOP] Press the [SHIFT] + [STOP] keys to bring all the
GANGED VTRs to the precise offset positions of the
selected VTR (during JOGGING or SHUTTLING
maneuvers the time relationship between the VTRs
may drift).
TIME MODE
SELECT
[TIME MODE] Press to toggle between Timecode (TC), VITC (VT)
or Tape Timer (TM) display modes.
PLAY [PLAY] If an OUT point is marked, play to the OUT point
and stop. If not OUT point is marked, play
normally.
If the CLIP ID ends with a ‘#’, do loop play.
PLAY- SIMPLE [SHIFT] + [PLAY] Play to end of clip, not Out Point.
RECUE [RECUE] If the IN point is marked, cue to the IN point. If IN
point is not marked, cue to the beginning of the
clip.
(Under BVW protocol, no action occurs if the IN
point is not marked.)
PBIO OPTION ONLY
PBIO ENABLE/
DISABLE
{PBIO} PBIO LED is ON if PBIO is enabled. Toggle the key
to temporarily disable all PBIO signals. The key
blinks when a valid PBIO command is received from
the Production Switcher.
Page 3 3 0 0 o o f f 3 3 9 9 2044CL Instant Clip Access System