DNF Controls 2044CL_(-A, -O, -NX, -7, -8, -T, -P) - Manual (Page 19)

9.
A.
B.
10.
11.
A.
B.
RECALL A CLIP OR CLIP COMBINATION
ON THE ST400
1) Select the desired Cue Point by pressing [NEXT CUE], [LAST CUE] or
by manually entering the Cue Point using the numeric keypad.
The selected Cue Point number is shown on the bottom of the display.
2) Press [LOAD] on the ST400.
The selected clip or clip combination will be loaded on the learned
channels, and cued to the learned IN point. The learned OUT point
and GANG mode will be set.
ON THE SHOTBOX
1) Select the desired BANK by pressing BANK [1], [2], [3], [4], [5],
[6], [7], [8], [9] or [0].
The Shotkeys will display the assigned CLIP IDs for the selected bank.
2) Press the desired Shotkey.
The selected clip or clip combination will be loaded on the learned
channels, and cued to the learned IN point. The learned OUT point
and GANG mode will be set.
RECUE CLIP
1) Press [RECUE]. If an IN Point is marked (the IN indicator is on), the
clip will RECUE to the IN Point.
If the IN point is not marked, the clip will RECUE to the start of the
clip.
2) Press {CUE OUT} to cue to the marked OUT point. If no OUT point
marked, the clip will not cue anywhere.
CLEAR CUE POINTS
ON THE ST400
1) Select the cue point to be cleared using [NEXT CUE], [LAST CUE], or
manually entering the cue point number.
2) Press [SHIFT] + [MARK].
The {CLR-CUE} softkey will be displayed on the bottom of the
display.
3) Press the {CLR-CUE} softkey to clear the cue point.
The cue point will be cleared and the display will return to the normal
screen.
OR
Press [ESC] to escape without clearing.
ON THE SHOTBOX
1) Select the desired BANK by pressing the desired bank key.
2) Press and hold the [SHIFT] key.
3) Press the desired Shotkey to be cleared.
After the cue point is cleared, the Shotkey will be blank.
2044CL Instant Clip Access System Page 1 1 5 5 o o f f 3 3 9 9