DNF Controls 2044CL_(-A, -O, -NX, -7, -8, -T, -P) - Manual (Page 33)

25. FUNCTION TABLE
Function Key Press Description
CUE TO OUT
POINT {CUE OUT} Press the {CUE OUT} softkey if OUT point is set,
cue to the OUT point. If out point is not set do
nothing.
FFWD
[FFWD] Press and HOLD to shuttle. Release key to stop.
Set WIND Speed in MENU.
GOTO
ENTERED TIME
[SHIFT] +
[RECUE]
Search the VTR to the manually entered time.
Use the ST400 numeric keypad. Then press
[ENTER] or [RECUE] to execute the command.
GANG SETUP {GANG} Individually press the VTR keys to be included in
the gang. The LED above the key will turn on.
Press the VTR key again to remove from gang. The
LED above the key will turn off. Press [ESC] to
exit.
Upon exiting, all members of the gang will have
their VTR LEDs turned on. The flashing LED shows
which VTR is currently selected.
SET IN POINT [IN] Press to set the IN POINT
DELETE IN
POINT [SHIFT] + [IN] Press the [SHIFT] + [IN] keys to clear the IN
POINT
SET OUT
POINT
[OUT] Press to set the OUT POINT
DELETE OUT
POINT [SHIFT] + [OUT] Press the [SHIFT] + [OUT] keys to clear the out
POINT
JOG [JOG] Select [JOG mode and enable Wheel.
LAST CUE [LAST] Step to the previous Cue Point Location.
LOOP [LOOP ENABLE] Plays the currently loaded clip in a continuous loop.
NEXT CUE [NEXT] Step to the next Cue Point Location.
RECORD [REC] Places VTR into the Record mode selected by
RECORD MODE in the SETUP MENU. Press
[SHIFT] + [RECORD].
REWIND
[RWD] Press and HOLD to shuttle. Release key to stop.
Set WIND Speed in MENU.
SHUTTLE [SHUTTLE] Select SHUTTLE mode and enable Wheel.
SLOMO
[SLOMO] Press [SLOMO] to slo-mo the VTR. Turn the Wheel
(or move the T-Bar, if available) to change the play
speed.
Press [SLOMO] to STILL frame
2044CL Instant Clip Access System Page 2 2 9 9 o o f f 3 3 9 9