DNF Controls 2044CL_(-A, -O, -NX, -7, -8, -T, -P) - Manual (Page 13)

4.
A.
B.
VIDEO SERVER SETUP
Select the communications protocol on the VIDEO SERVER to be controlled
that corresponds to the version of the controller
A=AMP
O=ODETICS
NX=LEITCH NEXIO
Assign a serial port on the VIDEO SERVER through which the ST400 will
control it.
NOTES: The VIDEO SERVER may not support LTC or VITC time modes.
The ST400 will default to Tape Time if a non-supported time mode is selected.
2044CL Instant Clip Access System Page 9 9 o o f f 3 3 9 9