DNF Controls 2044CL_(-A, -O, -NX, -7, -8, -T, -P) - Manual (Page 16)

7.
A.
B.
C.
8.
A.
SET IN AND OUT POINTS
Press VTR [1], [2], [3], [4], [5], or [6] ({7 } or {8} on -7 or -8 version),
to select the channel to learn.
Load a clip on the selected channel. See Section: 5; LOAD A CLIP.
Use the transport functions to view the clip.
Press [IN] to mark an IN point. The IN LED will turn on.
Press [OUT] to mark an OUT point. The OUT LED will turn on.
To delete an IN or OUT point, press and hold [DEL], then press [IN] or
[OUT].
The IN/OUT LED will turn off.
LEARN A CLIP OR A CLIP COMBINATION
BVW MODE
a) Select the desired Cue Point by pressing [NEXT CUE],
[LAST CUE], or by manually entering the Cue Point
using the numeric keypad.
The selected Cue Point number is shown on the bottom
line of the display.
b) Locate the clip to the desired IN time. Press [IN] to
mark the IN time.
c) Locate the clip to the desired OUT time. Press [OUT] to
mark the OUT time.
d) Press [SHIFT] + [MARK] to start the LEARN.
The first line of the display will show:
“Select VTRs to learn------”
e) Press VTR [1], VTR [2], VTR [3] VTR[4], VTR[5],
and/or VTR[6] , ({7 } or {8} on -7 or -8 version), to
select the VTR to be learned into the current Cue Point.
If the VTRs are ganged, select one VTR that is part of
the Gang. The rest of the Gang will learn automatically.
f) Press [MARK] to complete the LEARN.
NOTE: Learn will overwrite the previous contents of the
Cue Point.
OR
Press [ESC] to exit without LEARNING.
g) The ST400 will: LEARN (save) the VTR number (1, 2,
3,4,5,6, (7, and 8 on -7 or -8 versions).) and current IN
& OUT time and gang to the selected Cue Point.
Page 1 1 2 2 o o f f 3 3 9 9 2044CL Instant Clip Access System