DNF Controls 2044CL_(-A, -O, -NX, -7, -8, -T, -P) - Manual (Page 17)

B. ON THE ST400
1) Press VTR [1], [2], [3], [4], [5], or [6] ({7 } or {8} on -7 or -8
version), to select the channel to learn.
2) Load a clip on the selected channel. See Section: 5; LOAD A CLIP.
3) Use the transport functions to view the clip.
Optional: Press [IN] to mark an IN point. The IN LED will turn on.
Optional: Press [OUT] to mark an OUT point. The OUT LED will turn
on.
To delete an IN or OUT point, press and hold [DEL], then press
[IN] or [OUT].
The IN/OUT LED will turn off.
If no IN point is marked, the current location of the clip will be
learned as the IN point.
4) For GANGs, repeat steps 1) thru 3) for each channel.
Then, press the {GANG} softkey.
Press VTR [1], [2], [3], [4], [5], or [6], ({7 } or {8} (on -7 OR -8
version), key to add it to the GANG. The VTR LED will turn on.
Press the VTR key again to remove it from the gang. The VTR LED will
turn off.
Press [ESC] to exit GANG mode. The LEDs of all GANGed VTRs will
turn on.
5) Select the desired Cue Point by pressing [NEXT CUE], [LAST CUE] or
by manually entering the Cue Point using the numeric keypad,
followed by [ENTER].
The selected Cue Point number is shown on the bottom part of the
display.
6) Press [SHIFT] + [MARK] to initiate the LEARN.
The display will show: “Select VTRs to learn:--------”
7) Select the VTRs to learn by pressing VTR keys [1], [2], [3], [4], [5],
or [6] , ({7 } or {8} on -7 or -8 version)..
8) Press [MARK] to complete the learn process.
Note: Learn will overwrite the previous contents of the Cue Point.
Press [ESC] anytime to escape without learning.
9) The ST400 will: LEARN (save) the VTR number (1, 2, 3,4,5,6, (7, or 8
on -7 or -8 versions)) and current IN & OUT time and gang to the
selected Cue Point.
2044CL Instant Clip Access System Page 1 1 3 3 o o f f 3 3 9 9