DNF Controls 2044CL_(-A, -O, -NX, -7, -8, -T, -P) - Manual (Page 21)

14.
A.
B.
C.
D.
15.
VIEW COUNTDOWN TIME (AMP PROTOCOL
ONLY)
Press {RT} softkey to enable the countdown mode on the current channel.
The countdown time is displayed on the first line of the display. The
countdown time is the remaining time till the OUT point, or, if the OUT
point is not marked, till the end of the clip.
If the OUT point is marked and the playout continues passed the OUT
point, the negative countdown is displayed.
Press {RT} softkey to disable the countdown mode on the current
channel.
NOTE: When RT mode is selected, the IN and OUT point are still
marked in either TM or LTC mode, depending on which mode is
selected by
[TIME MODE] key.
BVW MODE
If you wish to control a tape machine or a DDR with the 2044CL-AMP
system, select control MODE=BVW (see Setup Menu section). In this
mode, the media is accessed by timecode, not by clip names. The
cuepoints in BVW mode consist only of IN point, OUT point and Gang
information.
The following functions are not available in BVW mode:
-
View Clip ID
-
Recue Clip
-
Loop Clip
-
Capture
-
Create Clip
-
Create Subclip
All other functions work as described in the manual.
2044CL Instant Clip Access System Page 1 1 7 7 o o f f 3 3 9 9