DNF Controls 2044CL_(-A, -O, -NX, -7, -8, -T, -P) - Manual (Page 23)

ADVANCED FEATURES . . .
16.
A.
B.
C.
D.
E.
F.
17.
A.
B.
C.
CREATING A CLIP
Press [CLIP LIST].
Press {CREATE}.
Manually enter an ID with a maximum of 32 characters from the ST400
numeric keypad, OR a PC keyboard, OR the Shotbox “QWERTY” keyboard.
NOTE: For numbers on the SHOTBOX keyboard, use bank keys [0]-[9].
Optional: Press [ENTER] to enter the start time/duration for the new clip.
Press {CREATE}.
The clip will be created with the entered CLIP ID.
If the selected CLIP ID already exists, a warning message will be
displayed. Press any key to continue.
Press [REC] to start the record process. The channel will stay in record for
the duration set in the "CREATE" dialogue or if no duration was set then
until the [STOP] button is pressed...
CAPTURE
This function allows clips to be recorded on to the Video Server from a video
source (SOURCE) such as a VTR. The SOURCE is connected to the VTR6
connector on the rear of the 2044CL-O.
Prior to performing a capture, press [MENU].
Set the PREROLL value for the SOURCE VTR. Typical value is 5 seconds.
Set the RECORD DELAY value. This is the record latency of the video server.
Typical value is 3 (frames).
Select the destination Video Server Channel. The destination channel may be
any VTR except VTR6.
Press VTR [6] to initiate the Capture function.
Set an IN point on the SOURCE VTR.
Jog/Shuttle to the desired IN point. Press [IN].
OR
Press [SHIFT] + [IN]. Manually enter the IN time on the numeric
keypad. Press [ENTER].
Set an OUT point on the SOURCE VTR.
Jog/Shuttle to the desired OUT point. Press [OUT].
OR
Press [SHIFT] + [OUT]. Manually enter the OUT time on the numeric
keypad. Press [ENTER].
2044CL Instant Clip Access System Page 1 1 9 9 o o f f 3 3 9 9