DNF Controls 2044CL_(-A, -O, -NX, -7, -8, -T, -P) - Manual (Page 18)

C.
a)
b)
c)
d)
a)
b)
c)
d)
ON THE SHOTBOX
1) PERFORM FOLLOWING ON THE ST400 FIRST
Press VTR [1], [2], [3], [4], [5], or [6] , ({7 } or {8} on -7 or -
8 version), to select the channel to learn.
Load a clip on the selected channel. See section: 5; LOAD A CLIP.
Use the transport functions to view the clip.
Optional: Press [IN] to mark an IN point. The IN LED will turn on.
Optional: Press [OUT] to mark an OUT point. The OUT LED will
turn on.
To delete an IN or OUT point, press and hold [DEL], then press
[IN] or [OUT].
The IN/OUT LED will turn off.
If no IN point is marked, the current location of the clip will be
learned as the IN point.
For GANGs, repeat steps a) and c) for each channel.
Then, press the {GANG} softkey.
Press VTR [1], [2], [3], [4], [5], or [6] , ({7} or {8} on -7 or -8
version), to add it to the GANG. The VTR LED will turn on.
Press the VTR key again to remove it from the gang. The VTR LED
will turn off.
Press [ESC] to exit GANG mode. The LEDs of all GANGed VTRs will
remain on.
2) THEN PERFORM FOLLOWING ON THE SHOT BOX
Press [LEARN]. The LEARN indicator will turn on.
Select the desired BANK by pressing BANK [1], [2], [3], [4], [5],
[6], [7], [8], [9] or [0].
Press the desired Shotkey to complete the learn process.
The learned CLIP ID is displayed on the Shotkey.
Press [LEARN] at anytime to escape without LEARNing.
Page 1 1 4 4 o o f f 3 3 9 9 2044CL Instant Clip Access System