DNF Controls 2044CL_(-A, -O, -NX, -7, -8, -T, -P) - Manual (Page 10)

2.
A.
B.
SYSTEM INSTALLATION
SHOTBOX
1) Plug one end of a standard 9-pin, RS422 serial cable into the OUTPUT
connector on the rear of the Shotbox. Plug the other end of the cable
into the “Shotbox” connector on the rear of the ST420.
2) Connect the supplied POWER SUPPLY, AULT#SW300, into the POWER
connector on the rear of the SHOTBOX. Plug the Power Supply into an
outlet, 90 VAC – 240 VAC.
ST400 VTR/DDR CONTROLLER
1) Plug one end of a 9-conductor, RS422 serial cable into the VTR1, 2, 3,
4, 5, or 6 (7 or 8 on -7 or -8 version) connector on the rear of the
ST400. Plug the other end of the cable into the 9-pin REMOTE
connector on the Video Server.
2) Connect the supplied POWER SUPPLY, APX #4108, into the POWER
connector on the rear of the ST400. Plug the Power Supply into an
outlet, 90 VAC - 240 VAC.
3) Attach Video Ref. cable (from House Ref.) to Ref. Video In on the rear
of the ST400 to utilize the capture function or the gang function.
4) Check SETUP MENU prior to using the ST400 to confirm proper Record
mode and other User settable modes.
Installation is complete.
Page 6 6 o o f f 3 3 9 9 2044CL Instant Clip Access System