DNF Controls 2034CL-O-PBIO vs.3.1 - Manual (Page 9)

9 2034CL-O, Vs. 3.1, 300 Clip Instant Access System, Odetics Protocol,
PBIO Option
3. VIDEO SERVER SETUP
a. Select ODETICS Broadcast communications protocol on the VIDEO SERVER to be
controlled.
b. Assign a serial port on the VIDEO SERVER through which the ST300 will control the
server.
NOTES: The VIDEO SERVER may not support LTC or VITC time modes in ODETICS
Broadcast mode. The ST300 will default to Tape Time if a non-supported time mode is selected
on the ST300.
The Grass Valley Group PROFILE does not support search to a time location using Timecode
(LTC or VITC) in ODETICS Protocol. Tape Time mode (TM) must be selected on the ST300.
In ODETICS Broadcast mode, the VIDEO SERVER may O
NLY allow Full Record. INSERT and
ASSEMBLE record modes may be disabled.
Setup is complete.
4. LOAD A CLIP
Only available in Odetics Control Mode.
a.
Select a VTR by pressing VTR[1], VTR[2], or VTR[3].
b. Press
[CLIP LIST] to view the list of CLIP IDs that are resident on the Video Server.
The CLIP LIST indicator will turn on.
c. Press
[LOAD] to create and load a new clip.
(Creating a clip is described in the CREATING A CLIP section.)
OR
Turn the Wheel to view the existing CLIP IDs on the video server.
Turn the Wheel clockwise to scroll forward, or counter-clockwise to scroll backward,
through the list of available CLIPs. Backward scrolling is limited to the last 10 CLIP IDs
viewed.
OR
Manually enter a CLIP ID using the ST300 numeric keypad, or PC keyboard (if KBIO
option).
OR
Manually enter a Clip ID using the Qwerty keyboard on SHOTBOX.