DNF Controls 2034CL-O-PBIO vs.3.1 - Manual (Page 11)

11 2034CL-O, Vs. 3.1, 300 Clip Instant Access System, Odetics Protocol,
PBIO Option
c. LEARN ON THE ST300
1)
Load a clip(s) on the desired VTR(s). (See “LOAD A CLIP” section.)
(Only in Odetics Control Mode.)
2) Select the desired Cue Point by pressing [NEXT CUE], [LAST CUE] or by
manually entering the Cue Point using the numeric keypad.
The selected Cue Point number is shown on the bottom line of the display.
3) Press
[SHIFT] + [MARK] to start the LEARN.
The first line of the display will show “Select VTRs:”
The second line of the display will show “Mark-Lrn, ESC-cancel.”
4) Press
VTR[1], VTR[2] or VTR[3] to select the VTR to be learned into the
current Cue Point.
If the VTRs are ganged, select one VTR that is part of the Gang. The rest of the
Gang will learn automatically.
5) Press [MARK] to complete the LEARN.
OR
Press [ESC] to exit without LEARNING.
The ST300 will: LEARN (save) the VTR Number (1,2,3), loaded CLIP ID and
current IN & OUT time to the selected Cue Point.
In BVW mode, the Clip ID is not learned.