DNF Controls 2034CL-O-PBIO vs.3.1 - Manual (Page 24)

24 2034CL-O, Vs. 3.1, 300 Clip Instant Access System, Odetics Protocol,
PBIO Option
For Wheel only:
Press Softkey [PRSET] to select the SLOMO Preset Speed Mode.
Press Softkey [UPDATE].
When exiting SLOMO mode, the last used speed is saved in the Preset Speed register.
OR
Press Softkey [STATIC].
The Preset Speed register is NOT updated when exiting SLOMO mode.
It is only changed by [SHIFT] + [SLOMO] (PRESET SLOMO).
GANG MODE Press Softkey to select PERMANENT GANG (described in the FUNCTION Table) or
TEMPORARY GANG.
In TEMPORARY mode, press and hold the VTR key that you want to read status from, then press
the VTR#s of those VTRs that you want to include in the gang. Release the keys. The LED on the
monitored VTR blinks, all other VTRs in the gang stay on constantly. To break the temporary gang,
press any VTR# key.
ST300
SETUP
Press Softkey beneath ClearCues to clear all Cue Points to 00:00:00:00.
Press Softkey [YES] when asked “Are You Sure?”
Press Softkey beneath SetDefault to set ST300 to default settings.
Press Softkey [YES] when asked “Are You Sure?”
IMPORTANT NOTE: Please set these items during initial installation.
DISPLAY
SOFTWARE
VERSION
The version number and date for the currently installed software is displayed. For example:
SYNC Set to ON if black burst is supplied to the Ref Video connector on the rear panel. Set to OFF if no
blackburst is supplied.
AUTO RECUE If Set to [ON] the video automatically recues back to the IN point (or to the beginning of the clip if
there is no IN point) after the playout reaches OUT point (or the end of the clip).
RECORD Press Softkey to select single button or 2-button record.
RECORD = [REC] Only.
OR
[REC] + [PLAY].
RECALL MODE Press [NORMAL] or [REDIR] (redirect).
NORMAL -
The cue point will load on the learned VTR.
REDIR -
When one and only one clip is learned into a Cue Point, the Clip will be REDIRECTED to load on
the currently selected VTR.
2034CL-O V3.1
072400
ST300 SETUP
Clear Cues SetDef ault