DNF Controls 2034CL-O-PBIO vs.3.1 - Manual (Page 12)

12 2034CL-O, Vs. 3.1, 300 Clip Instant Access System, Odetics Protocol,
PBIO Option
8. RECALL A CLIP OR CLIP COMBINATION
a. RECALL ON THE PRODUCTION SWITCHER
RECALL the desired REGISTER NUMBER.
The ST300 will automatically load the Learned clips on the Learned VTRs, cue the clips
to the Learned time, then set the Learned GANG mode.
In BVW mode, Clips are not loaded, the video is positioned to learned IN point.
b. RECALL ON THE SHOTBOX
1) Select the desired Bank.
2) Press the desired shotkey.
The ST300 will automatically load the learned clips on the learned VTRs, cue
the clips to the Learned time, then set the Learned Gang Mode.
In BVW mode, Clips are not loaded, the video is positioned to learned IN point.
c. RECALL ON THE ST300
1) Select the desired Cue Point by pressing [NEXT CUE], [LAST CUE] or
by manually entering the Cue Point using the numeric keypad.
The selected Cue Point number is shown on the bottom line of the display.
2) Press
[LOAD] on the ST300.
The ST300 will automatically load the Learned clips on the Learned VTRs, cue
the clips to the Learned time, then set the Learned GANG mode. If RECALL
MODE in the Setup Menu is set to REDIR, and a cue point contains only one
clip, then the clip will be REDIRECTED to load on the currently selected VTR,
not the Learned VTR.
In BVW mode, Clips are not loaded, the video is positioned to learned IN point.