DNF Controls 2034CL-O-PBIO vs.3.1 - Manual (Page 13)

13 2034CL-O, Vs. 3.1, 300 Clip Instant Access System, Odetics Protocol,
PBIO Option
9. RECUE THE CURRENTLY LOADED CLIP
Press [RECUE]. If an IN Point is marked (the IN indicator is on), the clip will RECUE to the IN
Point.
If the IN point is not marked, the clip will RECUE to the start of the clip.
OR
Press [SHIFT] + [RECUE].
a.
Enter the desired time to search to using the ST300’s numeric keypad.
b. Press [ENTER] to search to the entered time.
OR
Press [ESC] to exit without searching.
10. PLAY CLIP
a. Load a clip from Cliplist or Recall a learned clip.
b.
Mark IN (OUT) points if desired. (See Section 13, “SETTING THE IN (OUT)
POINTS.”)
c. Press [PLAY].
The clip will play from the current point to the OUT point or, if no OUT point is marked,
to the end of the clip.
If Autorecue Option is ON (see Setup Menu), the clip will recue to the IN point (or the
beginning of the clip) once the OUT point (or the end of the clip) is reached.
11. LOOP CLIP
Only available in Odetics Control Mode.
a. LOAD a clip from CLIPLIST or RECALL a learned clip.
b. Press [LOOP ENABLE] to a loaded clip. The LOOP ENABLE indicator will turn on.
The second line of the display will show “Looping clip . . .”
c. Press [STOP] to stop the loop play.
If the clip ID ends with an asterisk (“*”), it will automatically loop when either [LOOP
ENABLE] or [PLAY] is pressed.